Cisco ONS 15454 DWDM Installation And Operation Manual page 278

DLP-G94 Verify Add and Drop Connections on OADM Node with OSC-CSM Card
b. Click the Provisioning > Optical Chn > Parameters tabs.
Change the Admin State of the CHAN RX port to OOS,MT/Locked,maintenance for the channel
c.
related to the wavelength selected on the tunable laser.
d. Verify that the Power value of the CHAN RX port reaches the provisioned setpoint (VOA Power
Ref).
Complete the
Step 4
OPT-PRE amplifier to verify that the added wavelength turns on the laser.
If the add connection uses a 4MD-xx.x card, continue with
Step 5
AD-xC-xx.x card, move to
Verify the west AD-xB-xx.x:
Step 6
Display the west AD-xB-xx.x card in card view.
a.
Click the Provisioning > Optical Band > Parameters tabs.
b.
Change the Admin State of the BAND TX port to OOS,MT/Locked,maintenance for the channel
c.
related to the wavelength selected on the tunable laser.
Verify that the Power value of the BAND TX port is higher than the default no-power value of
d.
–30 dBm.
Step 7 Display the related AD-xB-xx.x card (west-to-east direction) in card view.
Change the admin state of the drop BAND TX port related to the wavelength selected on the tunable
Step 8
laser to OOS,MT.
(Optional.) Connect a power meter to the proper 15xx.xs TX port on the front panel (the dual port
Step 9
compared with the port where the tunable laser is connected). Verify that the physical optical power
value from that port is consistent with the value displayed on the Provisioning > Optical Chn >
Parameters tab for the proper CHAN TX power value +/– 0.5 dB.
Verify the west AD-xC-xx.x (west-to-east) card:
Step 10
a. Display the west AD-xC-xx.x card in card view.
Click the Provisioning > Optical Chn > Parameters tabs.
b.
Verify that the Power value of the CHAN TX port is higher than the default no-power value of
c.
–35 dBm.
d. Display the east AD-xC-xx.x in card view.
e. Click the Provisioning > Optical Chn > Parameters tabs.
Verify that the power value for the CHAN TX port is higher than the default no-power value of
f.
–35 dBm.
g. If the AD-xC-xx.x card is an AD-4C-xx.x card, a VOA (applied to all four channels) is installed
along the drop path and needs to be configured.
Change the Admin State of the CHAN TX port related to the wavelength selected on the tunable
h.
laser to OOS,MT/Locked,maintenance. Click Apply.
Perform the output power check.
i.
(Optional.) Connect a power meter to the proper 15xx.xx TX port on the front panel (the dual port
Step 11
compared with the port where the tunable laser is connected). Verify that the physical optical power
value from that port is consistent with the value on Provisioning > Optical Chn > Parameters tab for the
proper CHAN TX power value +/– 0.5 dB.
Repeat Steps
Step 12
east-to-west direction.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
4-36
"DLP-G80 Verify the OPT-PRE Amplifier Laser and Power" task on page 4-23
Step 10.
6 through 11 for all add paths of any west AD-xC-xx.x or 4MD-xx.x cards along the
Chapter 4 Perform Node Acceptance Tests
Step 6. If the add connection uses an
on the west
September 2004