Row Display Options; Applying Alarm Profiles; Figure 20-5 Card View Of An E1000-2-G Card Alarm Profile - Cisco ONS 15454 DWDM Installation And Operation Manual

Hide thumbs Also See for ONS 15454 DWDM:

Table of Contents

20.5.5 Row Display Options

In the network or node view, the Alarm Profiles window (Alarm Profile Editor for Node view) displays

three check boxes at the bottom of the window:

In CTC node view, the Alarm Behavior window displays alarm profiles for the node. In card view, the

Alarm Behavior window displays the alarm profiles for the selected card. Alarm profiles form a

hierarchy. A node-level alarm profile applies to all cards in the node except cards that have their own

profiles. A card-level alarm profile applies to all ports on the card except ports that have their own

At the node level, you can apply profile changes on a card-by-card basis or set a profile for the entire

node. At the card-level view, you can apply profile changes on a port-by-port basis or set alarm profiles

for all ports on that card.

Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7

Only show service-affecting severities—If unchecked, the editor shows severities in the format

sev1/sev2 where sev1 is a service-affecting severity and sev2 is not service-affecting. If checked, the

editor only shows sev1 alarms.

Hide reference values—Highlights alarms with nondefault severities by clearing alarm cells with

default severities.

Hide identical rows—Hides rows of alarms that contain the same severity for each profile.

shows the E1000-2-G card view of an alarm profile.

Alarm Monitoring and Management

September 2004