Dlp-G159 Refresh Automatic Power Control Information; Ntp-G78 View Roadm Node Power Equalization - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G159 Refresh Automatic Power Control Information

Step 4 Return to your originating procedure.
DLP-G159 Refresh Automatic Power Control Information
Purpose
Tools/Equipment
Prerequisite Procedures All procedures in
Required/As Needed
Onsite/Remote
Security Level
Click the Maintenance > DWDM > APC tabs.
Step 1
Click Refresh.
Step 2
Return to your originating procedure.
Step 3
Stop. You have completed this procedure.

NTP-G78 View ROADM Node Power Equalization

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
In node view, click the Maintenance > DWDM > Power Monitoring tabs.
Step 2
On the Power Monitoring tab, view the following east-to-west (E > W) and west-to-east (W > E) power
Step 3
information:
•
•
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
9-6
This procedure refreshes the DWDM automatic power control information.
A node provisioning plan prepared by Cisco MetroPlanner is required.
As needed
Onsite or remote
Superuser
This task allows you to view reconfigurable optical add/drop multiplexing
(ROADM) node power equalization levels.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Superuser
"DLP-G46 Log into CTC" task on page
Padd—Add power.
Ppt—Pass-through power.
Pout—Output power. The output power for all wavelengths does not need to be exactly the same for
all wavelengths, but does need to be within the same range.
ROADM node with equalized output power.
Chapter 3, "Turn Up a Node."
2-25. If you are already logged in, continue with
Figure 9-1
Chapter 9 Manage the Node
shows an example of
September 2004