Ntp-G74 Monitor Dwdm Card Performance; Dlp-G139 View Optical Service Channel Pm Parameters - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G74 Monitor DWDM Card Performance

NTP-G74 Monitor DWDM Card Performance
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
If you are already logged in, continue with
Step 2 Complete the following tasks as needed:
•
•
•
•
•
Note
Stop. You have completed this procedure.

DLP-G139 View Optical Service Channel PM Parameters

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
8-8
"DLP-G46 Log into CTC" procedure on page 2-25
DLP-G139 View Optical Service Channel PM Parameters, page
DLP-G140 View Optical Amplifier PM Parameters, page
DLP-G141 View PMs for 32MUX-O, 32-WSS, 32-DMX-O, and 32DMX Cards, page
DLP-G142 View Channel Filter Optical Add/Drop Multiplexer PM Parameters, page
DLP-G143 View Band Filter Optical Add/Drop Multiplexer PM Parameters, page
To refresh, reset, or clear PM counts, see the
page 8-2.
This procedure enables you to view, transmit, and receive performance
information about an Optical Service Channel, Multiplexer/Demultiplexer,
Amplifier, and OADM card and port during selected time intervals to
detect possible performance problems.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and Circuits" and Chapter 10, "Change Card Settings."
As needed
Onsite or remote
Retrieve or higher
Step 2.
"NTP-G73 Change the PM Display" procedure on
This task enables you to view optical service channel (OSC) PM counts
at selected time intervals on an Optical Service Channel Module
(OSCM) or Optical Service Channel and Combiner/Separator Module
(OSC-CSM) card and port to detect possible performance problems.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
Chapter 8 Monitor Performance
Chapter 6, "Create Channels
at the node that you want to monitor.
8-8.
8-10.
8-14.
8-11.
8-12.
September 2004