Dlp-G150 View Payload Utilization Pm Parameters; Figure 8-13 Utilization Tab On The Card View Performance Window - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G150 View Payload Utilization PM Parameters

DLP-G150 View Payload Utilization PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click theMXP_MR_2.5G or MXPP_MR_2.5G card where you want to view PM
counts. The card view appears.
Step 2 Click the Performance > Payload PM > Utilization tabs

Figure 8-13 Utilization Tab on the Card View Performance Window

Card View
Performance tab
Utilization tab
Payload PM tab
Click Refresh. Performance monitoring utilization values appear for each port on the card.
Step 3
View the Port # column to find the port you want to monitor.
Step 4
The transmit (Tx) and receive (Rx) bandwidth utilization values for the previous time intervals appear
Step 5
in the Prev-n columns. For PM parameter definitions, refer to the Cisco ONS 15454 SONET and DWDM
Troubleshooting Guide.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
8-24
This task enables you to view line utilization PM counts on an
MXP_MR_2.5G or MXPP_MR_2.5G card and port to detect possible
performance problems.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
Interval Refresh Help
menu button button
Chapter 8
(Figure 8-13).
Monitor Performance
September 2004