Dlp-G174 Switch Between Tdm And Dwdm Network Views; Ntp-G83 Modify Or Delete Card Protection Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G174 Switch Between TDM and DWDM Network Views

DLP-G174 Switch Between TDM and DWDM Network Views
Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
From the Network Scope drop-down list on the toolbar, choose one of the following:
Step 2
•
•
•
Return to your originating procedure (NTP).
Step 3

NTP-G83 Modify or Delete Card Protection Settings

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Modifying and deleting protection groups can be service affecting.
Complete the
Step 1
Step 2.
Step 2 Complete the
Step 3 Perform any of the following tasks as needed:
•
•
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
9-20
Use this task to switch between TDM (time division multiplexing) and
DWDM (dense wavelength division multiplexing) network views.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
All—Displays both TDM and DWDM nodes
TDM—Displays only ONS 15454s with SONET or SDH cards including the transponder and
muxponder cards.
DWDM—Displays only ONS 15454s with DWDM cards, including the transponder and muxponder
cards.
This procedure modifies and deletes card protection settings.
None
NTP-G33 Create a Y-Cable Protection Group, page 3-33
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page
"NTP-G103 Back Up the Database" procedure on page
DLP-G175 Modify a Y-Cable Protection Group, page 9-21
DLP-G176 Modify a Splitter Protection Group, page 9-22
DLP-G177 Delete a Y-Cable Protection Group, page 9-22
Chapter 9
2-25. If you are already logged in, continue with
11-2.
Manage the Node
September 2004