Dlp-G127 Modify Alarm, Condition, And History Filtering Parameters - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G127 Modify Alarm, Condition, and History Filtering Parameters

Alarm filtering will be enabled in the card, node, and network views of the Alarms tab at the node and
for all other nodes in the network. If, for example, the Alarm Filter tool is enabled in the Alarms tab of
the node view at one node, the Alarms tab in the network view and card view of that node will also show
the tool enabled. All other nodes in the network will also have the tool enabled.
If you filter an alarm in card view, the alarm will still be displayed in node view. In this view, the card
will display the color of the highest-level alarm. The alarm is also shown for the node in the network
view.
If you want alarm filtering enabled when you view conditions, repeat Steps
Step 3
window.
If you want alarm filtering enabled when you view alarm history, repeat Steps
Step 4
window.
Return to your originating procedure (NTP).
Step 5
DLP-G127 Modify Alarm, Condition, and History Filtering Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
At the node, network, or card view, click the Alarms tab, Conditions tab, or History tab.
Step 1
Click the Filter button on the left side of the bottom toolbar.
Step 2
The filter dialog box appears, displaying the General tab.
the Conditions and History tabs have similar dialog boxes.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
7-30
This task changes alarm and condition reporting in all network nodes.
None
DLP-G126 Enable Alarm Filtering, page 7-29
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
Chapter 7
1 and 2
1 and
Figure 7-13 shows the Alarm Filter dialog box;
Manage Alarms
using the Conditions
2 using the History
November 2004