Dlp-G66 Install Fiber-Optic Cables For A Hub Node - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G66 Install Fiber-Optic Cables for a Hub Node

6 East OSCM RX to east OPT-BST OSC TX
7 East OPT-BST LINE TX to west OPT-BST or OSC-CSM LINE RX on adjacent node
8 East OPT-BST LINE RX to west OPT-BST or OSC-CSM LINE TX on adjacent node
Plug one end of a fiber into the west OPT-BST or OSC-CSM LINE TX connector and the other end into
Step 2
the adjacent node east OPT-BST or OSC-CSM LINE RX connector. Repeat in the other direction (east
to west, TX to RX). Always connect the west line ports to the adjacent node east line ports.
Note
If OSCM cards are not installed, continue with
Step 3
a.
b.
c.
d.
Repeat Steps
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-G66 Install Fiber-Optic Cables for a Hub Node
Purpose
Tools
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Refer to the Cisco MetroPlanner internal connections table for your site when completing connections.
Before you begin hub node connections, read the following rules:
•
•
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
3-40
Cards display an SF LED after the OSC terminations are created (see the
Terminations and Ring ID" procedure on page
connected correctly. For example, an RX port is connected to another RX port or a TX port is
connected to another TX port.
Plug one end of a fiber into the west OPT-BST OSC RX connector and the other end into west
OSCM OSC TX connector.
Plug another fiber into the west OSCM OSC RX connector and the other end to the west OPT-BST
OSC TX connector.
plug one end of a fiber into the east OPT-BST OSC RX connector and the other end into east OSCM
TX connector.
Plug another fiber into the east OSCM OSC RX connector and the other end to the east OPT-BST
OSC TX connector.
2 and 3 at each node in the network.
This task installs fiber-optic cables on a hub node DWDM shelf.
Fiber-optic cables
NTP-G115 Clean Fiber Connectors, page 11-32
As needed
Onsite
None
The west OPT-BST or OSC-CSM card common (COM) TX port is connected to the west
OPT-PRE COM RX port or the west 32DMX-O COM RX port.
The west OPT-PRE COM TX port is connected to the west 32DMX-O COM RX port.
The west 32MUX-O COM TX port is connected to the west OPT-BST or west OSC-CSM COM RX
port.
3-60) and transmit and receive fibers are not
Step 4. If OSCM cards are installed.
Chapter 3 Turn Up a Node
"NTP-G38 Provision
September 2004