Figure 7-13 Alarm Filter Dialog Box General Tab; Figure 7-14 Alarm Filter Dialog Box Conditions Tab - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 7 Manage Alarms

Figure 7-13 Alarm Filter Dialog Box General Tab

In the General tab Show Severity box, you can choose which alarm severities will show through the
alarm filter and provision a time period during which filtered alarms show through the filter. To change
the alarm severities shown in the filter, go to
to Step
Step 3 In the Show Severity area, click the check boxes for the severities [Critical (CR), Major (MJ), Minor
(MN), or Not-Alarmed (NA)] you want to be reported at the network level. Leave severity check boxes
deselected (unchecked) to prevent those severities from appearing.
When alarm filtering is disabled, all alarms show.
In the Time area, click the Show alarms between time limits check box to enable it. Click the up and
Step 4
down arrows in the From Date, To Date, and Time fields to modify what period of alarms are shown.
To modify filter parameters for conditions, continue with
continue with
Step 5 Click the filter dialog box Conditions tab

Figure 7-14 Alarm Filter Dialog Box Conditions Tab

November 2004
4.
Step 6.
DLP-G127 Modify Alarm, Condition, and History Filtering Parameters
Step 3. To change the time period filter for the alarms, go
Step 5. If you do not need to modify them,
(Figure 7-14).
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
7-31