Maintaining The Power System In The Cisco Cbr Chassis; Removing The Ac Power Connections From The Cisco Cbr Chassis - Cisco cBR Series Manual

Revised: October 8, 2018

Maintaining the Power System in the Cisco cBR Chassis

Removing the AC Power Connections from the Cisco cBR Chassis

Warning
The chassis ground connection must always be made first and disconnected last.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030
Before you begin
Required Tools and Equipment
• #2 Phillips screwdriver
Procedure
Step 1
Power down the AC FPEM using the power switch.
Step 2 Power down the AC circuit or power source to which the AC power cord is connected.
Step 3
Loosen the Phillips-head screw on the cable retaining bracket using a #2 Phillips screwdriver.
Step 4 Unplug the AC power cord from the receptacle on the AC FPEM.
Figure 1: Removing AC Power Cord from the AC FPEM
1 Screw on the cable retaining bracket
Step 5 Repeat Step 2, on page 2
2
to Step 4, on page 2 for each AC power connection.
2 AC power cord