Dlp-G215 Change Optical Line Optics Thresholds For The 32Wss Card; Table 10-17 32Wss Card Optical Line Optics Threshold Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G215 Change Optical Line Optics Thresholds for the 32WSS Card

DLP-G215 Change Optical Line Optics Thresholds for the 32WSS Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the 32WSS card where you want to change the optical line optics warning
Step 1
threshold settings.
Click the Provisioning > Optical Line tab.
Step 2
Click the Optics Thresholds tab to display the warnings thresholds settings for each line.
Step 3
Modify any of the settings described in
Step 4

Table 10-17 32WSS Card Optical Line Optics Threshold Settings

Parameter Description
Port Display only. Line designation information is read-only.
The EXP-RX port receives an optical signal from another
32WSS module in the same network element. The EXP-TX
port sends an optical signal to the other 32WSS module
within the network element. For example, the two EXP
ports are designated as 66 LINE-16-1-RX and
65 LINE-16-1-TX.
The COM-TX port sends an aggregate optical signal to a
booster card (for example, OSC-CSM or OSCM) for
transmission outside of the network element. The
COM-RX port receives the optical signal from a
preamplifier and sends it to the optical splitter. For
example, the two COM ports are designated as
67 LINE-16-2-TX and 68 LINE-16-2-RX.
The DROP-TX port sends the split-off optical signal that
contains drop channels to the 32DMX card where the
channels are further processed and dropped. For example,
the DROP-TX port is designated as 69 LINE-16-3-TX.
opwrMin Sets the warning thresholds minimum value (dBm).
(dBm)
opwrMin Sets the warning thresholds maximum value (dBm).
(dBm)
Select the threshold alert type by clicking either the Warning or the Alarm radio button.
Step 5
Select the warning threshold interval by selecting either the 15 Min or 1 Day radio button.
Step 6
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-28
This task changes the optical line optics threshold settings for the 32WSS
card.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table 10-17.
Chapter 10
Options
—
User-defined value. Typically a negative
optical power setting.
User-defined value. Typically a positive
optical power setting.
Change Card Settings
September 2004