Ntp-G101 Modify Alarm Interface Controller-International Settings; Dlp-G245 Change External Alarms Using The Aic-I Card - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G101 Modify Alarm Interface Controller–International Settings
NTP-G101 Modify Alarm Interface Controller–International
Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
AIC-I card settings. If you are already logged in, proceed to
Complete the
Step 2
Perform any of the following tasks as needed:
Step 3
•
•
•
Complete the
Step 4
Stop. You have completed this procedure.

DLP-G245 Change External Alarms Using the AIC-I Card

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The procedure is the same if you are using the alarm expansion panel (AEP). In this case, the number of
Note
contacts that are shown on the screen is changed accordingly.
Confirm that external-device relays are wired to the ENVIR ALARMS IN pins. See the
Step 1
Install Alarm Wires on the MIC-A/P (ETSI Only)" task on page 1-48
Wires on the Backplane (ANSI Only)" task on page 1-53
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-80
This procedure provisions the AIC-I card to receive input from or send
output to external devices wired to the backplane (called external alarms
and controls or environmental alarms), or to change orderwire settings.
None
NTP-G72 Provision External Alarms and Controls on the Alarm Interface
Controller-International, page 7-38
DLP-G109 Provision Orderwire, page 6-15
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
"NTP-G103 Back Up the Database" procedure on page
DLP-G245 Change External Alarms Using the AIC-I Card, page 10-80
DLP-G246 Change External Controls Using the AIC-I Card, page 10-81
DLP-G247 Change AIC-I Card Orderwire Settings, page 10-82
"NTP-G103 Back Up the Database" procedure on page
This task changes external alarm settings on the AIC-I card.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Chapter 10
at the node where you want to change the
Step 2.
11-2.
11-2.
(ETSI) or "DLP-G23 Install Alarm
(ANSI) for more information.
Change Card Settings
"DLP-G20
September 2004