Dlp-G118 Display Alarms And Conditions Using Time Zone; Dlp-G119 Synchronize Alarms - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 7 Manage Alarms
Step 4 Return to your originating procedure (NTP).

DLP-G118 Display Alarms and Conditions Using Time Zone

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the Edit menu, choose Preferences.
Step 1
The CTC Preferences dialog box appears
Check the Display Events Using Each Node's Timezone check box. The Apply button is enabled.
Step 2
Click Apply and OK.
Step 3
Step 4 Return to your originating procedure (NTP).

DLP-G119 Synchronize Alarms

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
At the card, node, or network view, click the Alarms tab.
Step 1
Click Synchronize.
Step 2
This button causes CTC to retrieve a current alarm summary for the card, node, or network. This step is
optional because CTC updates the Alarms window automatically as raise/clear messages arrive from the
node.
Note
November 2004
This task changes the timestamp for events to the timezone of the ONS
node reporting the alarm. By default, the events timestamp is set to the
timezone for the CTC workstation.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
This task is used to view ONS 15454 events at the card, node, or network
level and to refresh the alarm listing so that you can check for new and
cleared alarms and conditions.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve
Alarms that have been raised during the session will have a check mark in the Alarms window
New column. When you click Synchronize, the check mark disappears.
DLP-G118 Display Alarms and Conditions Using Time Zone
(Figure 7-4 on page 7-10).
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
7-11