Dlp-G262 Clean Fiber Connectors With Cletop; Dlp-G263 Clean The Fiber Adapters - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G262 Clean Fiber Connectors with CLETOP

DLP-G262 Clean Fiber Connectors with CLETOP
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Remove the dust cap from the fiber connector.
Press the lever down to open the shutter door. Each time you press the lever, you expose a clean wiping
Step 2
surface.
Insert the connector into the CLETOP cleaning cassette slot, rotate one quarter turn, and gently swipe
Step 3
downwards.
Use an inspection microscope to inspect each fiber connector for dirt, cracks, or scratches. If the
Step 4
connector is not clean, repeat Steps
Insert the fiber connector into the applicable adapter or attach a dust cap to the fiber connector.
Step 5
Note
Return to your originating procedure (NTP).
Step 6

DLP-G263 Clean the Fiber Adapters

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Remove the dust plug from the fiber adapter.
Step 1
Step 2 Insert a CLETOP stick swab (14100400) into the adapter opening and rotate the swab.
Step 3 Place dust plugs on the fiber adapters when not in use.
Step 4 Return to your originating procedure (NTP).
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
11-34
This task cleans the fiber connectors with CLETOP.
Type A Fiber Optic Connector Cleaner (CLETOP reel)
Optical receiver cleaning stick
None
Required
Onsite
None
If you must replace a dust cap on a connector, first verify that the dust cap is clean. To clean the
dust cap, wipe the outside of the cap using a dry, lint-free wipe and the inside of the dust cap
using a CLETOP stick swab (14100400).
This task cleans the fiber adapters.
CLETOP stick swab
None
Required
Onsite
None
1 to 3.
Chapter 11 Maintain the Node
September 2004