Txp_Mr_2.5G And Txpp_Mr_2.5G Safety Labels; Figure 14-53 Txp_Mr_2.5G And Txpp_Mr_2.5G Block Diagram - Cisco ONS 15454 DWDM Installation And Operation Manual

Hide thumbs Also See for ONS 15454 DWDM:
Table of Contents

Advertisement

14.8.3 TXP_MR_2.5G and TXPP_MR_2.5G Cards

Figure 14-53 TXP_MR_2.5G and TXPP_MR_2.5G Block Diagram

Switch
SFP Client
CPU to
CPU
GCC
CELL
BUS
SCL BUS
CELL BUS
Caution
You must use a 20-dB fiber attenuator (15 to 25 dB) when working with the TXP_MR_2.5G and
TXPP_MR_2.5G cards in a loopback on the trunk port. Do not use direct fiber loopbacks with the
TXP_MR_2.5G and TXPP_MR_2.5G cards. Using direct fiber loopbacks causes irreparable damage to
the TXP_MR_2.5G and TXPP_MR_2.5G cards.
You can install TXP_MR_2.5G and TXPP_MR_2.5G cards in Slots 1 to 6 and 12 to 17. You can
provision this card in a linear configuration. TXP_MR_10G and TXPP_MR_2.5G cards cannot be
provisioned as a BLSR, a path protection, or a regenerator. They can be used in the middle of BLSR or
1+1 spans. They can only be used in the middle of BLSR and 1+1 spans when the card is configured for
transparent termination mode.
The TXP_MR_2.5G card features a 1550-nm laser for the trunk/line port and a 1310-nm laser for the
client port and contains two transmit and receive connector pairs (labeled) on the card faceplate. The
card uses dual LC connectors for optical cable termination.
The TXPP_MR_2.5G card features a 1550-nm laser for the trunk/line port and a 1310-nm or 850-nm
laser (depending on the SFP) for the client port and contains three transmit and receive connector pairs
(labeled) on the card faceplate. The card uses dual LC connectors for optical cable termination.
The TXP_MR_2.5G and TXPP_MR_2.5G cards detect SF, LOS, or LOF conditions on the optical
facility. Refer to the Cisco ONS 15454 SONET and DWDM Troubleshooting Guide for a description of
these conditions. The card also counts section and line BIP errors from B1 and B2 byte registers in the
section and line overhead.

14.8.3.3 TXP_MR_2.5G and TXPP_MR_2.5G Safety Labels

The TXP_MR_2.5G and TXPP_MR_2.5G cards have several safety labels that provide laser radiation
and electrical shock warnings.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
14-98
2R Tx path
2R Rx path
Mux
Main
Demux
ASIC
CPU
I/F
Protect
ASIC
FPGA
DCC
SCL
FPGA
Switch
Driver
Mux
Demux
Switch
Switch
Mux
Demux
Chapter 14
Trunk
Tunable
Out
Laser
Limiting
Main
Cross
Amp
APD+TA
Limiting
Protect
Amp
APD+TA
Card Reference
December 2004

Advertisement

Table of Contents
loading

Table of Contents