Dlp-G92 Verify An 4Md-Xx.x Pass-Through Connection Power - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G92 Verify an 4MD-xx.x Pass-Through Connection Power

Step 4 Return to your originating procedure (NTP).
DLP-G92 Verify an 4MD-xx.x Pass-Through Connection Power
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Verify the TX band power on the related east AD-xB-xx.x card:
Step 1
a.
b.
c.
d.
Verify the TX power on the related east 4MD-xx.x (east-to-west) card:
Step 2
a.
b.
c.
d.
Verify the west 4MD-xx.x (east-to-west):
Step 3
a.
b.
c.
d.
Step 4 Verify the west AD-xB-xx.x (west-to-east):
a.
b.
c.
d.
Verify the west 4MD-xx.x (west-to-east):
Step 5
a.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
4-32
This task verifies an 4MD-xx.x pass-through connection.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Superuser only
Display the east AD-xB-xx.x card in card view.
Click the Provisioning > Optical Band > Parameters tabs.
Change the Admin State of the BAND TX port to OOS,MT/Locked,maintenance for the channel
related to the wavelength selected on the tunable laser.
Verify that the BAND TX Power value is higher than the default no-power value of –30 dBm.
Display the east 4MD-xx.x card in card view.
Click the Provisioning > Optical Chn > Parameters tabs.
Verify that the Power value on the CHAN TX port is higher than the default no-power value of
–35 dBm.
Change the Admin State of the CHAN RX port to OOS,MT/Locked,maintenance for the channel
related to the wavelength selected on the tunable laser.
Display the west 4MD-xx.x card in card view.
Click the Provisioning > Optical Chn > Parameters tabs.
Change the Admin State of the CHAN RX port to OOS,MT/Locked,maintenance for the channel
related to the wavelength selected on the tunable laser.
Verify that the Power value of the CHAN RX port reaches the provisioned setpoint (VOA Power
Ref).
Display the west 4MD-xx.x card in card view.
Click the Provisioning > Optical Band > Parameters tabs.
Change the Admin State of the BAND TX port to OOS,MT/Locked,maintenance for the channel
related to the wavelength selected on the tunable laser.
Verify that the BAND TX Power value is higher than the default no-power value of –30 dBm.
Display the west 4MD-xx.x card in card view.
Chapter 4 Perform Node Acceptance Tests
September 2004