Chapter 9 Manage The Node; Before You Begin - Cisco ONS 15454 DWDM Installation And Operation Manual

Manage the Node
This chapter explains how to modify node provisioning for the Cisco ONS 15454 and perform common
management tasks such as monitoring the dense wavelength division multiplexing (DWDM) automatic
power control and span loss values. To provision a new node, see
change default network element settings and to view a list of those settings, refer to the Cisco ONS 15454
Release 4.7 Network Element Defaults document.
Unless otherwise specified, "ONS 15454" refers to both ANSI and ETSI shelf assemblies.
Note

Before You Begin

Before performing the following procedures, investigate all alarms and clear any trouble conditions.
Refer to the Cisco ONS 15454 SONET and DWDM Troubleshooting Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
8.
9.
September 2004
NTP-G76 Verify Span Loss, page
DWDM span loss values.
NTP-G77 Manage Automatic Power Control, page
manage the DWDM automatic power control.
NTP-G78 View ROADM Node Power Equalization, page
to view and update a reconfigurable optical add/drop management node power equalization.
NTP-G79 Modify Automatic Node Setup Parameters, page
NTP-G80 Change Node Management Information, page
change node name, contact information, latitude, longitude, date, time, and login legal disclaimer.
NTP-G81 Change CTC Network Access, page
the IP address, default router, subnet mask, network configuration settings, and static routes.
NTP-G82 Customize the CTC Network View, page
create domains and customize the appearance of the network map, including specifying a different
default map, creating domains, selecting your own map or image, and changing the background
color.
NTP-G83 Modify or Delete Card Protection Settings, page
NTP-G84 Initiate and Clear Y-Cable and Splitter External Switching Commands, page
9-23—Complete as needed.
C H A P T E R
9-2—Complete this procedure as needed to view or modify the
9-4—Complete this procedure as needed to
9-6—Complete this procedure as needed
9-8—Complete this procedure as needed to
9-10—Complete this procedure as needed to change
9-15—As needed, complete this procedure to
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
Chapter 3, "Turn Up a Node."
9-7—Complete as needed.
9-20—Complete as needed.
9
To
9-1