Cards; Dlp-G228 Change Line Otn Settings For Mxp_2.5G_10G And Mxp_2.5G_10E Cards; Table 10-34 Mxp_2.5G_10G Or Mxp_2.5G_10E Muxponder Card Line Otn Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G228 Change Line OTN Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards

DLP-G228 Change Line OTN Settings for MXP_2.5G_10G and MXP_2.5G_10E

Cards

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the MXP_2.5G_10G or MXP_2.5G_10E card where you want to change the
Step 1
line OTN settings.
Step 2 Click one of the Provisioning > OTN tabs (OTN Lines, OTN G.709 Thresholds, FEC Thresholds, or
Trail Trace Identifier tab).
Modify any of the settings described in Tables
Step 3
Table 10-34
Note

Table 10-34 MXP_2.5G_10G or MXP_2.5G_10E Muxponder Card Line OTN Settings

Parameter
Port #
G.709 OTN
FEC
SF BER
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-52
This task changes the line OTN settings for MXP_2.5G_10G or
MXP_2.5G_10E muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
describes the values on the Provisioning > OTN > OTN Lines tab.
In Table 10-34, some parameter tabs or values do not always apply to both the MXP_2.5G_10G
and MXP_2.5G_10E cards. When the tabs or values do not apply, they do not appear to the user.
Description
Display only. Displays the port number.
Sets the OTN lines according to ITU-T
G.709.
Sets the OTN line FEC mode. FEC mode
can be Disabled or Enabled. Enhanced
FEC mode can be enabled (to provide
greater range and lower bit error rate).
E-FEC applies only to the
MXP_2.5G_10E card.
Sets the signal fail bit error rate.
10-34 through 10-37.
Options
5
Enabled
•
Disabled
•
Disabled (FEC OFF)
•
Standard (FEC ON)
•
Enhanced (E-FEC ON)
•
1E-5
•
Chapter 10 Change Card Settings
September 2004