Ntp- G92 Modify Line Settings And Pm Parameter Thresholds For Multiplexer And Demultiplexer Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G92 Modify Line Settings and PM Parameter Thresholds for Multiplexer and Demultiplexer Cards
NTP-G92 Modify Line Settings and PM Parameter Thresholds for
Multiplexer and Demultiplexer Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Refer to the "Performance Monitoring" chapter in the Cisco ONS 15454 SONET and DWDM
Note
Troubleshooting Guide for more information on MUX and DMX parameters.
Complete the
Step 1
32MUX-O, 32DMX, or 4MD-xx.x card settings. If you are already logged in, proceed to
Complete the
Step 2
Step 3 Perform any of the following tasks as needed:
•
•
•
•
Complete the
Step 4
Stop. You have completed this procedure.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-16
This procedure changes the line and PM parameter threshold settings for
the multiplexer and demultiplexer cards. The cards included in this
category are the 32MUX-O,32DMX-O,32DMX, and4MD-xx.x cards.
None
NTP-G30 Install the DWDM Cards, page 3-26
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
"NTP-G103 Back Up the Database" procedure on page
DLP-G208 Change Optical Line Settings for Multiplexer and Demultiplexer Cards, page 10-17
DLP-G209 Change Optical Line Threshold Settings for Multiplexer and Demultiplexer Cards, page
10-18
DLP-G210 Change Optical Channel Settings for Multiplexer and Demultiplexer Cards, page 10-19
DLP-G211 Change Optical Channel Threshold Settings for Multiplexer and Demultiplexer Cards,
page 10-21
"NTP-G103 Back Up the Database" procedure on page
Chapter 10 Change Card Settings
at the node where you want to change the
11-2.
11-2.
Step 2.
September 2004