Figure 1-7 Removing The Ons 15454 Etsi Front Door - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP- G10 Remove the Front Door
b. Remove the ground wire from the shelf.
Hold the door at the top left corner and remove the door from its hinges
c.
Figure 1-7
Assembly hinge pin
Assembly hinge
For ONS 15454 ANSI shelves:
Step 2
To remove the door ground strap (available in Release 3.3 and later), perform the following:
a.
Lift the door from its hinges at the top left corner of the door
b.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
1-22
Removing the ONS 15454 ETSI Front Door
Translucent
circles
for LED
viewing
Door hinge
• To detach the ground strap from the front door, loosen the #6 Kepnut (49-0600-01) using the
open-end wrench. Detach the end of the ground strap terminal lug (72-3622-01) from the male
stud on the inside of the door.
To detach the other end of the ground strap from the longer screw on the fiber guide, loosen the
•
#4 Kepnut (49-0337-01) on the terminal lug using the open-end wrench. Remove the terminal
lug and lock washer.
Chapter 1
F A N
F A IL
C R
IT
M A
J
M IN
Install the Shelf and Common Control Cards
(Figure 1-7).
(Figure 1-8).
September 2004