Ntp-G106 Reset Cards Using Ctc; Dlp-G250 Reset The Tcc2 Card - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G106 Reset Cards Using CTC

Step 13 Set the node name and network configuration to site-specific values. See the
Management Information" procedure on page 9-8
procedure on page 9-10
gateway, and IIOP port.
Step 14 Return to your originating procedure (NTP).
NTP-G106 Reset Cards Using CTC
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
TCC2 reset. If you are already logged in, continue with
As needed, complete the
Step 2
As needed, complete the
Step 3
Stop. You have completed this procedure.

DLP-G250 Reset the TCC2 Card

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
circuitry could constitute an energy hazard.
Before you reset the TCC2, you should wait at least 60 seconds after the last provisioning change you
Note
made to avoid losing any changes to the database.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
11-10
for information on provisioning the node name, IP address, subnet mask and
This procedure resets the TCC2 and DWDM cards using CTC.
None
DLP-G33 Install the TCC2 Card, page 1-73
As needed
Onsite or remote
Superuser
"DLP-G46 Log into CTC" task on page 2-25
"DLP-G250 Reset the TCC2 Card" task on page
"DLP-G251 Reset DWDM Cards Using CTC" task on page
This task resets the TCC2 card and switches the node to the redundant
TCC2.
None
DLP-G33 Install the TCC2 Card, page 1-73
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Superuser
and the "NTP-G81 Change CTC Network Access"
at the node where you are performing the
Step 2.
11-10.
Chapter 11 Maintain the Node
"NTP-G80 Change Node
11-11.
September 2004