Dlp-G224 Change Section Trace Settings For Mxp_2.5G_10G And Mxp_2.5G_10E Cards; Table 10-30 Txp_Mr_10G And Mxp_Mr_10E Muxponder Card Section Trace Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Change Card Settings
DLP-G224 Change Section Trace Settings for MXP_2.5G_10G and
MXP_2.5G_10E Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the MXP_2.5G_10E or MXP_2.5G_10E card where you want to change the
Step 1
section trace settings.
Step 2 Click the Provisioning > Line > Section Trace tab.
Note
Step 3 Modify any of the settings described in

Table 10-30 TXP_MR_10G and MXP_MR_10E Muxponder Card Section Trace Settings

Parameter
Port
Trace Mode
Section Trace
String Size
Transmit
Expected
Received
September 2004

DLP-G224 Change Section Trace Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards

This task changes the section trace settings for MXP_2.5G_10G and
MXP_2.5G_10E muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
The Section Trace tab appears only if you have created a PPM for the card.
Description
Sets the port number.
Sets the trace mode.
Sets the trace string size. Select either
radio button.
Displays the current transmit string;
sets a new transmit string. You can select
the Hex Mode or ASCII Mode button to
change string input type.
Displays the current expected string;
sets a new expected string. You can select
the Hex Mode or ASCII Mode button to
change string input type.
Display only. Displays the current
received string. You can press the Refresh
button to manually refresh this display, or
select the Auto-refresh every 5 sec check
box to keep this panel updated.
Table 10-30.
Options
1
•
2
•
3
•
4
•
Off/None
•
Manual
•
1 byte
•
16 byte
•
String of trace string size
String of trace string size
String of trace string size
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-47