Dlp-G209 Change Optical Line Threshold Settings For Multiplexer And Demultiplexer Cards; Table 10-11 Multiplexer And Demultiplexer Card Optical Line Thresholds Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G209 Change Optical Line Threshold Settings for Multiplexer and Demultiplexer Cards

Table 10-10 Multiplexer and Demultiplexer Card Optical Line Settings (continued)
Parameter Description
Type Identifies the type of port. Display only.
Power Display only. Shows the current power level per
port.
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-G209 Change Optical Line Threshold Settings for Multiplexer and
Demultiplexer Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click the multiplexer or demultiplexer cards where you want to change the optical
line threshold settings.
Click the Provisioning > Optical Line > Optics Thresholds tabs.
Step 2
Modify any of the settings described in
Step 3

Table 10-11 Multiplexer and Demultiplexer Card Optical Line Thresholds Settings

Parameter
Port
Power Low
(dBm)
Power High
(dBm)
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-18
This task changes the optical line threshold settings for 32MUX-O,
32DMX-O, 32DMX, and 4MD-xx.x multiplexer and demultiplexer cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
Description
Display only. Displays the port number.
Set the low power settings.
Set the high power settings.
Options
• Input Com
• Output Com
Input Line
•
Output Line
•
Input OSC
•
Output OSC
•
—
10-11.
Options
—
Numeric. Can be set for 15-minute or
one-day intervals for Warning or Alarm.
Select the bullet and click Refresh.
Numeric. Can be set for 15-minute or
one-day intervals for Warning or Alarm.
Select the bullet and click Refresh.
Chapter 10 Change Card Settings
September 2004