Dlp-G60 Set Up Or Change Routing Information Protocol - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G60 Set Up or Change Routing Information Protocol

If you changed the Area ID, the TCC2 cards reset, one at a time. The reset takes approximately
10 to 15 minutes.
Return to your originating procedure (NTP).
Step 9
DLP-G60 Set Up or Change Routing Information Protocol
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Network > RIP tabs.
Step 1
Check the RIP Active check box if you are activating RIP.
Step 2
Choose either RIP Version 1 or RIP Version 2 from the drop-down list, depending on which version is
Step 3
supported in your network.
Set the RIP metric. The RIP metric can be set to a number between 1 and 15 and represents the number
Step 4
of hops.
By default, RIP is set to No Authentication. If the router that the ONS 15454 is connected to requires
Step 5
authentication, complete the following steps. If not, continue with
a.
b.
c.
The authentication button label changes to Simple Password.
If you want to complete an address summary, complete the following steps. If not, continue with
Step 6
Complete the address summary only if the ONS 15454 is a gateway NE with multiple external ONS
15454 NEs attached with IP addresses in different subnets.
a.
b.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
3-18
Table 3-1 on page 3-12
This task enables Routing Information Protocol (RIP) on the ONS 15454.
Perform this task if you want to include the ONS 15454 in RIP-enabled
networks.
None
DLP-G46 Log into CTC, page 2-25
You need to create a static route to the router adjacent to the ONS 15454
for the ONS 15454 to communicate its routing information to
non-DCC-connected nodes.
As needed
Onsite or remote
Provisioning or higher
Click the No Authentication button.
In the Edit Authentication Key dialog box, complete the following:
Type—Choose Simple Password.
•
Enter Authentication Key—Enter the password,
•
Confirm Authentication Key—Enter the same password to confirm it.
•
Click OK.
In the RIP Address Summary area, click Create.
In the Create Address Summary dialog box, complete the following:
Summary Address—Enter the summary IP address.
•
Mask Length—Enter the subnet mask length using the up and down arrows.
•
shows the LED behavior during the TCC2 reset.
Step
Chapter 3 Turn Up a Node
6.
Step
September 2004
7.