Dlp-G112 Delete Overhead Circuits; Ntp-G62 Create A J0 Section Trace - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G112 Delete Overhead Circuits

Step 8 Return to your originating procedure (NTP).
DLP-G112 Delete Overhead Circuits
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Deleting overhead circuits is service affecting if the circuits are in service (IS). To put circuits out of
Caution
service (OOS), see the
From the View menu, choose Go to Network View.
Step 1
Click the Provisioning > Overhead Circuits tabs.
Step 2
Click the overhead circuit that you want to delete: local or express orderwire, user data, IP-encapsulated
Step 3
tunnel, or DCC tunnel.
Click Delete.
Step 4
In the confirmation dialog box, click Yes to continue.
Step 5
Return to your originating procedure (NTP).
Step 6

NTP-G62 Create a J0 Section Trace

Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the section trace. If you are already logged in, continue with Step 2.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
6-18
This task deletes overhead circuits. Overhead circuits include
IP-encapsulated tunnels, AIC and AIC-I card orderwire, and user data
channels.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
"DLP-G108 Change the Service State for a Port" task on page
This procedure creates a repeated, fixed-length string of characters used to
monitor interruptions or changes to traffic between nodes.
At least one of the following cards must be installed: MXP_MR_2.5G,
MXPP_MR_2.5G, TXP_MR_2.5G, TXPP_MR_2.5G, MXP_2.5G_10E,
TXP_MR_10E, MXP_2.5G_10G, or TXP_MR_10G.
As needed (optional if path trace is set)
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
Chapter 6 Create Channels and Circuits
at a node on the network where you will
6-14.
September 2004