Dlp-G253 Place Oscm And Osc-Csm Ports Out Of Service - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 11 Maintain the Node
Step 3 Under Admin State, choose OOS,DSLB for each port that does not have an OOS-MA,DSLB service
state.
Click Apply.
Step 4
Step 5 In the confirmation dialog box, click Yes.
Step 6 Return to your originating procedure (NTP).

DLP-G253 Place OSCM and OSC-CSM Ports Out of Service

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
On the shelf graphic in CTC, double-click the OSCM or OSC-CSM card with the ports you want to put
Step 1
out of service.
Click the Provisioning > OC3 > OC3 tabs.
Step 2
Under Admin State, choose OOS,DSLB for each port that does not have an OOS-MA,DSLB service
Step 3
state.
Click Apply.
Step 4
In the confirmation dialog box, click Yes.
Step 5
Click the Provisioning > Optical Line > Parameters tabs.
Step 6
Under Admin State, choose OOS,DSLB for each port that does not have an OOS-MA,DSLB service
Step 7
state.
Click Apply.
Step 8
In the confirmation dialog box, click Yes.
Step 9
Return to your originating procedure (NTP).
Step 10
September 2004
DLP-G253 Place OSCM and OSC-CSM Ports Out of Service
This task places OSCM and OSC-CSM card ports out of service in
preparation for card removal.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
11-15