Dwdm Card Specifications; Oscm Card Specifications - Cisco ONS 15454 DWDM Installation And Operation Manual

B.4 DWDM Card Specifications
•
B.4 DWDM Card Specifications
This section provides specifications for the OSCM, OSC-CSM, OPT-PRE amplifier, OPT-BST amplifier,
32MUX-O, 32DMX-O, 32DMX, 4MD-xx.x, AD-IC-xx.x, AD-2C-xx.x, AD-4C-xx.x, AD-1B-xx.x,
AD-4B-xx.x, and 32WSS cards.
For compliance information, refer to the Cisco Optical Transport Products Safety and Compliance
Information document.
B.4.1 OSCM Card Specifications
•
•
•
•
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
B-12
Compliance: Installed ONS 15454 ETSI cards comply with these safety standards:
IEC 60950, EN 60950, UL 60950, CSA C22.2 No. 60950, TS 001, AS/NZS 3260
–
Line
Bit rate: 155 Mbps
–
– Code: Scrambled non-return to zero (NRZ)
– Loopback modes: None
– Connector: Duplex LC
Compliance: Telcordia GR-253-CORE, ITU-T G.957
–
Transmitter optical service channel (OSC) signal
Maximum transmitter output power: –1 dBm
–
Minimum transmitter output power: –5 dBm
–
Nominal wavelength: 1510-nm +/–10 nm
–
Variable optical attenuator (VOA) necessary in the transmit path to adjust the in-fiber optical
–
power level
Receiver OSC signal
Maximum receiver level: –8 dBm at 10
–
Minimum receiver level: –40 dBm at 10
–
– Span budget: 40-dB span budget (about 150 km assuming fiber path loss equals 0.25 dB/km)
Jitter tolerance: Telcordia GR-253/G.823 compliant
–
Environmental
Operating temperature:
–
C-Temp: –5 to +55 degrees Celsius (+23 to +131 degrees Fahrenheit)
Operating humidity: 5 to 95%, noncondensing
–
Dimensions
– Height: 12.65 in. (321.3 mm)
– Width: 0.92 in. (23.4 mm)
Depth: 9.00 in. (228.6 mm)
–
Appendix B
–10
BER
–10
BER
Hardware Specifications
April 2006