Ntp- G97 Modify Line Settings And Pm Parameter Thresholds For Mxp_2.5G_10G And Mxp_2.5G_10E Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Change Card Settings
NTP-G97 Modify Line Settings and PM Parameter Thresholds for
MXP_2.5G_10G and MXP_2.5G_10E Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
muxponder card settings. If you are already logged in, proceed to
Step 2 Complete the
Step 3 Perform any of the following tasks as needed:
•
•
•
•
•
•
•
Step 4 Complete the
Stop. You have completed this procedure.
September 2004
NTP-G97 Modify Line Settings and PM Parameter Thresholds for MXP_2.5G_10G and MXP_2.5G_10E Cards
This procedure changes the line and threshold settings for
MXP_2.5G_10G and MXP_2.5G_10E muxponder cards.
None
NTP-G32 Install the Transponder and Muxponder Cards, page
DLP-G63 Install an SFP, page 3-32
NTP-G94 Provision Pluggable Port Modules, page
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
"NTP-G103 Back Up the Database" procedure on page
DLP-G222 Change Card Settings for MXP_2.5G_10G and MXP 2.5G_10E Cards, page 10-44
DLP-G223 Change Line Settings for MXP_2.5G_10G and MXP 2.5G_10E Cards, page 10-45
DLP-G224 Change Section Trace Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards, page
10-47
DLP-G225 Change Trunk Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards, page 10-48
DLP-G226 Change Line Thresholds Settings for MXP_2.5G_10G and MXP 2.5G_10E Cards, page
10-49
DLP-G227 Change Optical Threshold Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards,
page 10-51
DLP-G228 Change Line OTN Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards, page 10-52
"NTP-G103 Back Up the Database" procedure on page
at the node where you want to change the
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
3-30.
10-29.
Step 2.
11-2.
11-2.
10-43