Dlp-G123 Apply Alarm Profiles To Ports - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 7 Manage Alarms
Step 6 If you want to download a profile that is stored locally or on a network drive, click From File in the
Load Profile dialog box.
a.
b.
c.
Note
Note
Click OK.
Step 7
The downloaded profile appears at the right side of the Alarm Profiles window.
Right-click anywhere in the downloaded profile column to view the profile editing shortcut menu.
Step 8
Click Store.
Step 9
In the Store Profiles dialog box, click To Node(s).
Step 10
a.
b.
Return to your originating procedure (NTP).
Step 11

DLP-G123 Apply Alarm Profiles to Ports

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the node view, double-click a card to open the card view.
Step 1
November 2004
Click Browse.
Navigate to the file location in the Open dialog box.
Click Open.
The Default alarm profile list contains alarm and condition severities that correspond when
applicable to default values established in Telcordia GR-253-CORE.
All default or user-defined severity settings that are Critical (CR) or Major (MJ) are demoted to
Minor (MN) in Non-Service-Affecting (NSA) situations as defined in Telcordia GR-474.
Choose the nodes where you want to save the profile:
• If you want to save the profile to only one node, click the node in the Node Names list.
• If you want to save the profile to all nodes, click Select All.
If you do not want to save the profile to any nodes, click Select None.
•
If you want to update alarm profile information, click Synchronize.
•
Click OK.
This task applies a custom or default alarm severity profile to a port or
ports.
None
DLP-G121 Create a New or Cloned Alarm Severity Profile, page 7-18
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G123 Apply Alarm Profiles to Ports
7-23