Dlp-G102 Filter The Display Of Optical Channel Network Connections - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G102 Filter the Display of Optical Channel Network Connections

Step 3 Return to your originating procedure (NTP).
DLP-G102 Filter the Display of Optical Channel Network Connections
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Navigate to the appropriate CTC view:
Step 1
•
•
•
Click the Circuits tab.
Step 2
Set the attributes for filtering the circuit display:
Step 3
a.
b.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
6-6
This task filters the display of OCHNCs and circuits in the Circuits
window. You can filter the circuits in network, node, or card view based on
circuit or OCHNC name, size, type, direction, and other attributes.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
To filter network circuits, choose View > Go to Network View.
To filter circuits that originate, terminate, or pass through a specific node, choose View >
Go to Other Node, then choose the node you want to search and click OK.
To filter circuits that originate, terminate, or pass through a specific card, double-click the card on
the shelf graphic in node view to open the card in card view.
Click the Filter button.
In the Circuit Filter dialog box, set the filter attributes by choosing one or more of the following:
Name—Enter a complete or partial circuit name to filter circuits based on the circuit name;
•
otherwise leave the field blank.
Direction—Choose one: Any (direction not used to filter circuits), 1-way (display only one-way
•
circuits), or 2-way (display only two-way circuits).
OCHNC Dir—(DWDM optical channel network connections only.) Choose one: East to West
•
(displays only east-to-west circuits); West to East (displays only west-to-east circuits).
OCHNC Wlen—(DWDM optical channel network connections only.) Choose an OCHNC
•
wavelength to filter the circuits. For example, choosing 1530.33 will display channels
provisioned on the 1530.33-nm wavelength.
Status—Choose one: Any (status not used to filter circuits), Discovered (display only
•
discovered circuits; OCHNCs have Discovered status only) or Partial (display only partial
circuits, that is, circuits missing a connection or span to form a complete path).
State—Choose one: OOS (ANSI) or Locked (ETSI) to display only out-of-service circuits; IS
•
(ANSI) or Unlocked (ETSI) to display only in-service circuits (optical channel network
connections have IS/Unlocked states only); or OOS-PARTIAL (ANSI) or
Locked-partial (ETSI) to display only circuits with cross-connects in mixed service states.
Slot—Enter a slot number to filter circuits based on the source or destination slot; otherwise
•
leave the field blank.
Chapter 6 Create Channels and Circuits
September 2004