Dlp-G143 View Band Filter Optical Add/Drop Multiplexer Pm Parameters - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G143 View Band Filter Optical Add/Drop Multiplexer PM Parameters

DLP-G143 View Band Filter Optical Add/Drop Multiplexer PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the AD-xB-xx.x or the 4MD-xxx card where you want to view PM counts.
Step 1
The card view appears.
Click the Performance > Optical Chn tabs
Step 2
Figure 8-5
Performance
Channel tab
radio buttons
radio buttons
Click Refresh. Optical channel performance monitoring statistics for the selected port appear.
Step 3
Click the Optical Band tab.
Step 4
Click Refresh. Optical band performance monitoring statistics for the selected port appear.
Step 5
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
8-14
Optical Channel Tab in the Band Filter OADM Card View Performance Window
Card View
tab
Optical
Directions
Intervals
This task enables you to view band filter OADM PM counts at selected
time intervals on an 1-Band OADM (AD-1B-xx.x), 4-Band OADM
(AD-4B-xx.x), or 4-Channel Multiplexer/Demultiplexer (4MD-xx.x)
card and port to detect possible performance problems.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
(Figure 8-5).
Signal-type Refresh
port menu button
Chapter 8 Monitor Performance
Auto-refresh Baseline Clear
menu button button
September 2004
Help
button