Dlp-G133 View Near-End Pm Counts; Dlp-G134 View Far-End Pm Counts - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G133 View Near-End PM Counts

Note
Return to your originating procedure (NTP).
Step 7
DLP-G133 View Near-End PM Counts
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card where you want to view PM counts. The card view appears.
Step 1
Click the Performance tab.
Step 2
Click the Near End radio button.
Step 3
Click Refresh. All PM parameters occurring for the selected card on the incoming signal appear. For
Step 4
PM parameter definitions, refer to the Cisco ONS 15454 SONET and DWDM Troubleshooting Guide.
View the Curr column to find PM counts for the current time interval.
Step 5
View the Prev-n columns to find PM counts for the previous time intervals.
Step 6
Return to your originating procedure (NTP).
Step 7

DLP-G134 View Far-End PM Counts

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card where you want to view PM counts. The card view appears.
Step 1
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
8-4
If a complete count over a 1-day interval is not possible, the value appears with a yellow
background. An incomplete or incorrect count can be caused by monitoring for less than
24 hours after the counter started, changing node timing settings, changing the time zone
settings, replacing a card, resetting a card, or changing port service states. When the problem is
corrected, the subsequent 1-day interval appears with a white background.
This task enables you to view near-end PM counts for the selected card
and port.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
This task enables you to view far-end PM parameters for the selected
card and port.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
Chapter 8 Monitor Performance
September 2004