Dlp-G33 Install The Tcc2 Card; Figure 1-29 Installing Cards In The Ons 15454 Etsi - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 1 Install the Shelf and Common Control Cards

Figure 1-29 Installing Cards in the ONS 15454 ETSI

Note
Complete the
Step 2
Continue with the
Step 3

DLP-G33 Install the TCC2 Card

Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
September 2004
F A N
F A IL
C R
IT
M A
Ejector
If you install the wrong card in a slot, see the
procedure on page 11-12.
DLP-G34 Install the AIC or AIC-I Card, page
"NTP-G16 Perform the Shelf Installation Acceptance Test" procedure on page
This task installs redundant TCC2 cards. The first card you install in the
ONS 15454 must be a TCC2 card, and it must initialize before you install
any cross-connect or traffic cards.
Two TCC2 cards
Required
Onsite
None
J
M IN
Guide rail
"NTP-G107 Remove and Replace DWDM Cards"
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP- G33 Install the TCC2 Card
1-76, if necessary.
1-77.
1-73