Ntp-G35 Route Fiber-Optic Cables - Cisco ONS 15454 DWDM Installation And Operation Manual

Hide thumbs Also See for ONS 15454 DWDM:
Table of Contents

Advertisement

Chapter 3
Turn Up a Node
6
West 32DMX COM RX to west 32WSS DROP TX
7
West 32WSS EXP TX to east 32WSS EXP RX
8
West 32WSS EXP RX to east 32WSS EXP TX
9
East 32DMX COM RX to east 32WSS DROP TX
10
East 32WSS COM RX to east OPT-PRE COM TX
11
East 32WSS COM TX to east OPT-BST COM RX
12
East OPT-BST COM TX to east OPT-PRE COM RX
13
East DCU RX to east OPT-PRE DC TX
14
East DCU TX to east OPT-PRE DC RX
1. If a DCU is not installed, a 5 dB attenuator loop must be installed between the OPT-PRE DC ports.
Note
Plug one end of the fiber into the desired RX port and the other into the correct TX port
Step 2
Repeat
Step 3
Return to your originating procedure (NTP).
Step 4

NTP-G35 Route Fiber-Optic Cables

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
Open the fold-down front door on the cable-management tray.
Step 2
Route the fiber cable on the card faceplate through the fiber clip on the faceplate, if provided. Fiber clips
are factory-attached to the faceplates of 32MUX-O, 32DMX-O, OSCM, OPT-PRE, and OPT-BST cards.
Route the fiber cables into the cable-management tray.
Step 3
Step 4
Route the fiber cables out either side of the cable-management tray through the cutouts on each side of
the shelf assembly. Use the reversible fiber guides to route cables out the desired side.
September 2004
1
1
Cards display an SF LED after the OSC terminations are created (see the
Terminations and Ring ID" procedure on page
connected correctly. For example, an RX port is connected to another RX port or a TX port is
connected to another TX port.
Step 2
until you have connected the nodes according to the site plan.
This procedure describes how to route fiber-optic cables.
None
NTP-G34 Install Fiber-Optic Cables on DWDM Cards, page 3-35
As needed
Onsite
None
3-60) and transmit and receive fibers are not
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
NTP-G35 Route Fiber-Optic Cables
"NTP-G38 Provision
3-55

Advertisement

Table of Contents
loading

Table of Contents