Dlp-G149 View Payload Statistics Pm Parameters; Figure 8-11 Viewing Otn Fec Performance Monitoring Information - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G149 View Payload Statistics PM Parameters

Figure 8-11 Viewing OTN FEC Performance Monitoring Information

Performance
FEC PM tab
OTN PM tab
radio buttons
radio buttons
View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Step 5
Curr (current) and Prev-n (previous) columns. For PM parameter definitions, refer to the
Cisco ONS 15454 SONET and DWDM Troubleshooting Guide.
Return to your originating procedure (NTP).
Step 6
DLP-G149 View Payload Statistics PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to view PM
Step 1
counts. The card view appears.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
8-22
Card View
tab
Directions
Intervals
Signal-type Refresh
port menu button
This task enables you to view current statistical PM counts on an
MXP_MR_2.5G or MXPP_MR_2.5G card and port to detect possible
performance problems.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
Chapter 8 Monitor Performance
Auto-refresh Baseline Clear
menu button button
September 2004
Help
button