Node View Shortcuts; Network View Tasks - Cisco ONS 15454 DWDM Installation And Operation Manual

Manage the CTC Window

Node View Shortcuts

Table A-5
window.
Table A-5
Action
Display card
information
Open, reset, or delete
a card
Preprovision a slot
Change a card

Network View Tasks

Right-click the network view graphic area or a node, span, or domain to display shortcut menus.
Table A-6
Table A-6
Action
Open a node
Move a node icon
Reset node icon
position
Provision a circuit
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
A-10
shows actions on ONS 15454 cards that you can perform by moving your mouse over the CTC
Node View Card-Related Shortcuts
Shortcut
In node view, move your mouse over cards in the graphic to display tooltips
with the card type, card status (active or standby), the highest level of alarm (if
any), and the alarm profile used by the card.
In node view, right-click a card. Choose Open Card to display the card in card
view, Delete Card to delete it, or Reset Card to reset the card.
In node view, right-click an empty slot. Choose the card type for which you
want to provision the slot from the shortcut menu.
In node view, right-click an OC-N card or a DS3 card, and choose
Change Card. In the Change Card dialog box, choose the card type.
Change Card retains all card provisioning, including data communications
channel (DCC) terminations, protection, circuits, and ring.
lists the actions that are available from the network view.
Network Management Tasks in Network View
Task
Any of the following:
• Double-click a node icon.
• Right-click a node icon and choose Open Node from the shortcut menu.
• Click a node and choose Go To Selected Object View from the View
menu.
• From the View menu, choose Go To Other Node. Choose a node from the
Select Node dialog box.
Double-click a node alarm or event in the Alarms or History tab.
•
Press the Ctrl key and the left mouse button simultaneously and drag the node
icon to a new location.
Right-click a node and choose Reset Node Position from the shortcut menu.
The node icon moves to the position defined by the longitude and latitude fields
on the Provisioning > General tab in node view.
Right-click a node. From the shortcut menu, choose Provision Circuit To and
choose the node where you want to provision the circuit. For circuit creation
procedures, see Chapter 6, "Create Channels and Circuits."
Appendix A CTC Information and Shortcuts
September 2004