Chapter 10
Change Card Settings
DLP-G208 Change Optical Line Settings for Multiplexer and Demultiplexer
Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the multiplexer or demultiplexer cards where you want to change the optical
Step 1
line settings.
Step 2
Click the Provisioning > Optical Line > Parameters tabs.
Modify any of the settings described in
Step 3
Table 10-10 Multiplexer and Demultiplexer Card Optical Line Settings
Parameter
Description
Port #
Displays the port number. Display only.
Port Name
Provides the ability to assign the specified port a
name.
Admin State
Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, "DWDM Enhanced State Model."
Line Direction Provides the ability to associate a card with the line
direction. Use this field if you have two cards in the
same shelf and must designate which one will carry
the traffic flow from east to west. The second card
will carry traffic from west to east.
Service State
Identifies the autonomously generated state that
gives the overall condition of the port. Service
states appear in the format: Primary State-Primary
State Qualifier, Secondary State. For more
information about service states, see
"DWDM Enhanced State Model."
September 2004
DLP-G208 Change Optical Line Settings for Multiplexer and Demultiplexer Cards
This task changes the optical line settings for 32MUX-O, 32DMX-O,
32DMX, and 4MD xx.x multiplexer and demultiplexer cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
10-10.
Options
Displays port number and TX or RX.
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default.
See the
page
6-8.
IS/Unlocked
•
IS,AINS/Unlocked,automaticInService
•
•
OOS,DSBLD/Locked,disabled
•
OOS,MT/Locked,maintenance
East to West
•
•
West to East
IS-NR/Unlocked-enabled
•
OOS-AU,AINS/Unlocked-disabled,
•
automaticInService
OOS-MA,DSBLD/Locked-enabled,disabled
•
Appendix C,
OOS-MA,MT/Locked-enabled,maintenance
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
"DLP-G104 Assign a Name to a Port" task on
10-17