Before You Begin - Cisco ONS 15454 DWDM Installation And Operation Manual

Install the Shelf and Common Control Cards
This chapter explains how to install the Cisco ONS 15454 ETSI and Cisco ONS 15454 ANSI shelf
assemblies. Where procedures differ for the two shelf types, the procedure will indicate "ANSI only" or
"ETSI only." For a summary of the tools and equipment required for installation, see the
and Equipment (ETSI)" section on page 1-4
page
Unless otherwise specified, "ONS 15454" refers to both ANSI and ETSI shelf assemblies.
Note

Before You Begin

This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs). Read
the installation procedures and precautions before you install the ONS 15454 ANSI or ONS 15454 ETSI
and connect the power source.
1.
2.
3.
4.
5.
6.
7.
8.
September 2004
1-2.
NTP-G1 Unpack and Inspect the Shelf Assembly, page
continuing with the "NTP-G2 Install the Shelf Assembly" procedure on page
NTP-G2 Install the Shelf Assembly, page
assembly in a rack.
NTP-G3 Open and Remove the Front Door, page
equipment before continuing with other procedures in this chapter.
NTP-G4 Open and Remove the FMEC Cover (ETSI Only), page
access the electrical facility connection assembly (EFCA) for the front mount electrical connections
(FMECs) before continuing with other procedures in this chapter.
NTP-G5 Remove the Backplane Covers (ANSI Only), page
access the backplane before continuing with other procedures.
NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only), page
procedure to install the MIC-A/P and MIC-T/C/P FMECs, which are required for power supply as
well as alarm, timing, and LAN connections.
NTP-G7 Install the Power and Ground, page
the "NTP-G8 Install the Fan-Tray Assembly" procedure on page
NTP-G8 Install the Fan-Tray Assembly, page
assembly in the shelf.
C H A P T E R
or the "Required Tools and Equipment (ANSI)" section on
1-6—Complete this procedure before
1-8—Complete this procedure to install the shelf
1-20—Complete this procedure to access the
1-26— Complete this procedure to
1-30—Complete this procedure before continuing with
1-40—Complete this procedure to install the fan-tray
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
1
"Required Tools
1-8.
1-23—Complete this procedure to
1-27—Complete this
1-40.
1-1