Card View; Table 17-10 Node Status Shown In Network View; Table 17-11 Network View Tabs And Subtabs - Cisco ONS 15454 DWDM Installation And Operation Manual

17.5.3 Card View

The color of a node in network view, shown in

Table 17-10 Node Status Shown in Network View

Color
Green
Yellow
Orange
Red
Gray with
Unknown#
Table 17-11

Table 17-11 Network View Tabs and Subtabs

Tab
Alarms
Conditions
History
Circuits
Provisioning
Maintenance
17.5.3 Card View
The card view provides information about individual ONS 15454 cards. Use this window to perform
card-specific maintenance and provisioning
shown in the graphic area. The status area displays the node name, slot, number of alarms, card type,
equipment type, card status (active or standby), card service state if the card is present, and port service
state (described in
perform depend on the card. For more information about card service states, refer to
"DWDM Enhanced State Model."
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
17-12
Alarm Status
No alarms
Minor alarms
Major alarms
Critical alarms
Node initializing for the first time (CTC displays Unknown# because CTC has
not discovered the name of the node yet)
lists the tabs and subtabs available in network view.
Description
Lists current alarms (CR, MJ, MN) for the
network and updates them in real time.
Displays a list of standing conditions on the
network.
Provides a history of network alarms including
date, type, and severity of each alarm.
Creates, deletes, edits, filters, and searches for
network circuits.
Provisions security, alarm profiles,
bidirectional line switched rings (BLSRs)
(ANSI), multiplex section-shared protection
rings (MS-SPRing) (ETSI), and overhead
circuits.
Displays the type of equipment and the status
of each node in the network; displays working
and protect software versions; and allows
software to be downloaded.
Table 17-7 on page
Chapter 17
Table 17-10, indicates the node alarm status.
(Figure 17-7). A graphic showing the ports on the card is
17-9). The information that appears and the actions you can
Cisco Transport Controller Operation
Subtabs
—
—
—
—
Security, Alarm Profiles, BLSR
(ANSI), MS-SPRing (ETSI),
Overhead Circuits, Provisionable
Patchcords
Software
Appendix C,
September 2004