Ntp-G73 Change The Pm Display; Dlp-G131 Refresh Pm Counts At 15-Minute Intervals; Chapter 8 Monitor Performance - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G73 Change the PM Display

NTP-G73 Change the PM Display
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
are already logged in, continue with
In node view, double-click the DWDM or multirate card where you want to view PM counts. The card
Step 2
view appears.
Step 3 As needed, use the following tasks to change the display of PM counts:
•
•
•
•
•
•
•
•
Stop. You have completed this procedure.

DLP-G131 Refresh PM Counts at 15-Minute Intervals

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
8-2
"DLP-G46 Log into CTC" task on page 2-25
DLP-G131 Refresh PM Counts at 15-Minute Intervals, page 8-2
DLP-G132 Refresh PM Counts at One-Day Intervals, page 8-3
DLP-G133 View Near-End PM Counts, page 8-4
DLP-G134 View Far-End PM Counts, page 8-4
DLP-G135 Reset Current PM Counts, page 8-5
DLP-G136 Clear Selected PM Counts, page 8-6
DLP-G137 Set Auto-Refresh Interval for Displayed PM Counts, page 8-6
DLP-G138 Refresh PM Counts for a Different Port, page 8-7
This procedure enables you to change the display of PM counts by
selecting drop-down list or radio button options in the Performance
window.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and Circuits" and Chapter 10, "Change Card Settings."
As needed
Onsite or remote
Retrieve or higher
Step 2.
This task changes the window view to display PM counts in 15-minute
intervals.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
Chapter 8 Monitor Performance
Chapter 6, "Create Channels
at the node that you want to monitor. If you
September 2004