Cisco ONS 15454 DWDM Installation And Operation Manual page 136

DLP- G33 Install the TCC2 Card
When installing cards, allow each card to boot completely before installing the next card.
Note
Open the latches/ejectors of the first TCC2 card that you will install.
Step 1
Use the latches/ejectors to firmly slide the card along the guide rails until the card plugs into the
Step 2
receptacle at the back of the slot (Slot 7 or 11).
Verify that the card is inserted correctly and close the latches/ejectors on the card.
Step 3
Note
If you insert a card into a slot provisioned for a different card, all LEDs turn off.
Step 4 Verify the LED activity of the TCC2 card:
All LEDs turn on briefly.
•
The red FAIL LED, the yellow ACT/STBY LED, the red REM LED, the green SYNC LED, and the
•
green ACO LED turn on for about 10 seconds.
The red FAIL LED and the green ACT/STBY LED turn on for about 40 seconds.
•
The red FAIL LED blinks for about 10 seconds.
•
The red FAIL LED turns on for about 5 seconds.
•
Both green PWR LEDs turn on for 5 seconds. The PWR LEDs then turn red for 2 to 3 minutes before
•
going to steady green.
All LEDs (including the CRIT, MAJ, MIN, REM, SYNC, and ACO LEDs) blink once and turn off
•
for about 10 seconds.
The ACT/STBY LED turns on. (The ACT/STBY LED might take several minutes to turn on while
•
the DCC processor boots.)
Note
Note
Verify that the ACT/STBY LED is green for active. The IP address for the node, the temperature of the
Step 5
ONS 15454, and the time of day should appear on the LCD. The default time and date is 12:00 AM,
January 1, 1970.
Verify that the correct software version appears on the LCD. (The LCD cycles through the IP address,
Step 6
node name, and software version.)
If the LCD shows the correct software version, continue with
Step 7
correct software version, upgrade the software or remove the TCC2 card and install a replacement card.
To replace the software, refer to the specific software upgrade document for your release.
Open the latches/ejectors of the redundant TCC2 card.
Step 8
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
1-74
It is possible to close the latches/ejectors when the card is not completely plugged into the back
panel of the shelf assembly. Ensure that you cannot insert the card any further.
Alarm LEDs might be on; disregard alarm LEDs until you are logged into the Cisco Transport
Controller (CTC) and can view the Alarms tab.
If the FAIL LED is on continuously, see the tip on page 75 about the TCC2 card automatic
upload.
Chapter 1 Install the Shelf and Common Control Cards
Step 8. If the LCD does not show the
September 2004