Dlp-G120 View Conditions - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G120 View Conditions

Step 3 Return to your originating procedure (NTP).
DLP-G120 View Conditions
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the card, node, or network view, click the Conditions tab.
Step 1
Click Retrieve
Step 2
The Retrieve button requests the current set of fault conditions from the node, card, or network. The
window is not updated when events change on the node. You must click Retrieve to see any changes.
Figure 7-5
Conditions include all fault conditions raised on the node, whether or not they are reported.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
7-12
This task is used to view conditions (events with a Not Reported [NR]
severity) at the card, node, or network level. Conditions give you a clear
record of changes or events that do not result in alarms.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
(Figure 7-5).
Node View Conditions Window
Chapter 7 Manage Alarms
November 2004