Dlp-G163 Modify A Static Route - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G163 Modify a Static Route

•
See the
Click Apply.
Step 3
If you changed a network field that will cause the node to reboot, such as the IP address, subnet mask,
or TCC CORBA Listener Port, the Change Network Configuration confirmation dialog box appears. If
you changed a gateway setting, a confirmation appropriate to the gateway field appears.
If a confirmation dialog box appears, click Yes.
Step 4
If you changed an IP address, subnet mask length, or TCC CORBA (IIOP) Listener Port, both
ONS 15454 TCC2 cards will reboot, one at a time. A TCC2 card reboot causes a temporary loss of
connectivity to the node, but traffic is unaffected.
Confirm that the changes appear on the Provisioning > Network > General tab. If the changes do not
Step 5
appear, repeat the task. Refer to the Cisco ONS 15454 SONET and DWDM Troubleshooting Guide as
necessary.
Return to your originating procedure (NTP).
Step 6
DLP-G163 Modify a Static Route
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Network tabs.
Step 1
Step 2 Click the Static Routing tab.
Click the static route you want to edit.
Step 3
Click Edit.
Step 4
In the Edit Selected Static Route dialog box, enter the following:
Step 5
•
•
•
See the
Step 6 Click OK.
Step 7 Return to your originating procedure (NTP).
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
9-12
Gateway Settings
"DLP-G56 Provision IP Settings" task on page 3-9
This task modifies a static route on an ONS 15454.
None
DLP-G46 Log into CTC, page 2-25
DLP-G58 Create a Static Route, page 3-15
As needed
Onsite or remote
Provisioning or higher
Mask
Next Hop
Cost
"DLP-G58 Create a Static Route" task on page 3-15
Chapter 9
for detailed field descriptions.
for detailed field descriptions.
Manage the Node
September 2004