Dlp-G61 Provision The Iiop Listener Port On The Ons 15454; Figure 3-6 Ctc Computer And Ons 15454S Residing Behind Firewalls - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G61 Provision the IIOP Listener Port on the ONS 15454

Figure 3-6 CTC Computer and ONS 15454s Residing Behind Firewalls
IIOP port
Private
network
CTC computer
Protected network
Stop. You have completed this procedure.
DLP-G61 Provision the IIOP Listener Port on the ONS 15454
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
If the Enable Proxy Server on port 1080 check box is checked, CTC will use port 1080 and ignore the
Note
configured IIOP port setting. If Enable Proxy Server is subsequently unchecked, the configured IIOP
listener port will be used.
In node view, click the Provisioning > Network > General tabs.
Step 1
Step 2 In the TCC CORBA (IIOP) Listener Port area, choose a listener port option:
•
•
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
3-20
Firewall
Unprotected
network
Port
filtering
External network
This task sets the IIOP listener port on the ONS 15454, which enables you
to access ONS 15454s that reside behind a firewall.
IIOP listener port number provided by your LAN or firewall administrator
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Default - TCC Fixed—Uses Port 57790 to connect to ONS 15454s on the same side of the firewall
or if no firewall is used (default). This option can be used for access through a firewall if Port 57790
is open.
Standard Constant—Uses Port 683, the CORBA default port number.
Other Constant—If Port 683 is not used, type the IIOP port specified by your firewall administrator.
The port cannot use any of the ports shown in
Firewall
Private
network
Port
filtering
Protected network
Table 3-2.
Chapter 3 Turn Up a Node
IIOP port
ONS 15454
IIOP port
ONS 15454
September 2004