DLP-G124 Apply Alarm Profiles to Cards and Nodes
DLP-G124 Apply Alarm Profiles to Cards and Nodes
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
In node view, click the Provisioning > Alarm Profiles > Alarm Behavior tab
Figure 7-11 Node View Alarm Profile
To apply profiles to a card:
Step 2
a.
b.
c.
To apply the profile to an entire node:
Step 3
a.
b.
c.
To reapply a previous alarm profile after you have applied a new one, select the previous profile and click
Step 4
Apply again.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
7-26
This task applies a custom or default alarm profile to cards or nodes.
None
DLP-G121 Create a New or Cloned Alarm Severity Profile, page 7-18
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Click a selection from the Profile column for the card.
Choose the new profile from the drop-down list.
Click Apply.
Click the Node Profile drop-down arrow at the bottom of the window
Choose the new alarm profile from the drop-down list.
Click Apply.
Chapter 7
Manage Alarms
(Figure
7-11).
(Figure
7-11).
November 2004