Dlp-G205 Change Optical Line Threshold Settings For Opt-Pre And Opt-Bst Amplifiers; Table 10-7 Opt-Pre And Opt-Bst Amplifiers Optical Line Thresholds Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G205 Change Optical Line Threshold Settings for OPT-PRE and OPT-BST Amplifiers

DLP-G205 Change Optical Line Threshold Settings for OPT-PRE and OPT-BST
Amplifiers
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the OPT-PRE or OPT-BST amplifier where you want to change the optical
Step 1
line threshold settings.
Step 2 Click the Provisioning > Optical Line > Optics Thresholds tabs.
Modify any of the settings described in
Step 3

Table 10-7 OPT-PRE and OPT-BST Amplifiers Optical Line Thresholds Settings

Parameter
Port
Power Low
(dBm)
Power High
(dBm)
Click Apply.
Step 4
Step 5 Return to your originating procedure (NTP).
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-12
This task changes the optical line threshold settings for OPT-PRE and
OPT-BST amplifier cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
Description
Display only. Displays the port number.
Set the low power settings.
Set the high power settings.
10-7.
Options
—
Numeric. Can be set for 15-minute or
one-day intervals for Warning or Alarm.
Select the bullet and click Refresh.
Numeric. Can be set for 15-minute or
one-day intervals for Warning or Alarm.
Select the bullet and click Refresh.
Chapter 10 Change Card Settings
September 2004