Mic-A/P Fmec Specifications (Etsi Only - Cisco ONS 15454 DWDM Installation And Operation Manual

B.3.4 MIC-A/P FMEC Specifications (ETSI only)
•
•
B.3.4 MIC-A/P FMEC Specifications (ETSI only)
The ONS 15454 ANSI does not support the MIC-A/P FMEC.
Note
•
•
•
•
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
B-10
– Power failure (0 to –38 VDC)
Undervoltage (–38 to –40.5 VDC)
–
Overvoltage (beyond –56.7 VDC)
–
Environmental
Operating temperature: –40 to 149 degrees Fahrenheit (–40 to +65 degrees Celsius)
–
Operating humidity: 5 to 95%, noncondensing
–
Power consumption (including AEP, if used): 8.00 W, 0.17 A, 27.3 BTU/hr
–
Dimensions
Height: 12.650 in. (321.3 mm)
–
Width: 0.716 in. (18.2 mm)
–
Depth: 9.000 in. (228.6 mm)
–
Weight: 1.8 lb (0.82 kg)
–
Power supply input BATTERY B
System supply voltage: Nominal –48 VDC
–
Tolerance limits: –40.5 to –57.0 VDC
Connector: 3WK3 Combo-D power cable connector
–
Alarm outputs
Voltage (open contact): Maximum 60 VDC
–
Current (closed contact): Maximum 250 mA
–
Connector: 62-pin DB connector (common for inputs/outputs)
–
Alarm inputs
– Voltage (open contact): Maximum 60 VDC
– Current (closed contact): Maximum 2 mA
– Connector: 62-pin DB connector (common for inputs/outputs)
Environmental
Operating temperature: –5 to +45 degrees Celsius (+23 to +113 degrees Fahrenheit)
–
Operating humidity: 5 to 95%, noncondensing
–
Power consumption: 0.13 W (provided by +5 V from the TCC2 card), 0.44 BTU/hr
–
Dimensions
Height: 182 mm (7.165 in.)
–
Width: 32 mm (1.25 in.)
–
Depth: 92 mm (3.62 in.)
–
Depth with backplane connector: 98 mm (3.87 in.)
–
Appendix B Hardware Specifications
April 2006