DLP-G243 Change External Controls Using the AIC Card
Step 4
Modify any of the following fields for each external device wired to the ONS 15454 backplane. For
definitions of these fields, see the
Interface Controller Card" procedure on page
•
•
•
•
•
•
To provision additional devices, complete Step
Step 5
Click Apply.
Step 6
Return to your originating procedure (NTP).
Step 7
DLP-G243 Change External Controls Using the AIC Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
Verify the external control relays to the ENVIR ALARMS OUT backplane pins. See the
Install Alarm Wires on the Backplane (ANSI Only)" task on page 1-53
Step 2
In node view, double-click the AIC card to display it in card view.
Step 3
Click the Provisioning > External Controls tabs.
Step 4
Modify any of the following fields for each external control wired to the ONS 15454 backplane. For
definitions of these fields, see the
Interface Controller Card" procedure on page
•
•
•
•
Step 5
To provision additional controls, complete
Step 6
Click Apply.
Return to your originating procedure (NTP).
Step 7
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-78
Enabled
Alarm Type
Severity
Virtual Wire
Raised When
Description
This task changes external control settings on the AIC card. This task
applies to ONS 15454 ANSI shelves only.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Enabled
Trigger Type
Control Type
Description
"NTP-G71 Provision External Alarms and Controls on the Alarm
7-36.
4
for each additional device.
"NTP-G71 Provision External Alarms and Controls on the Alarm
7-36.
Step 4
for each additional device.
Chapter 10
Change Card Settings
"DLP-G23
for more information.
September 2004