Cisco ONS 15454 DWDM Installation And Operation Manual page 502

DLP-G238 Change OC48 Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
Table 10-50 MXP_MR_2.5G and MXPP_MR_2.5G Muxponder Card Line Distance Extension Settings
Parameter
Credits
Available
Autothreshold
GFP Buffers
GFP Buffers
Available
Click Apply.
Step 4
Step 5 Return to your originating procedure (NTP).
DLP-G238 Change OC48 Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
OC48 settings apply only to the trunk ports (9 for MXP_MR_2.5G and 9 and 10 for MXPP_MR_2.5G)
Note
In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to change the
Step 1
OC48 settings.
Click the Provisioning > Line > OC48 tab. Tabs and parameter selections vary according to PPM
Step 2
provisioning.
Step 3 Modify any of the settings for the OC48 Extension tab as described in
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-70
Description
Display only. Displays the number of
buffer credits available.
This parameter allows the threshold of the
GFP buffer between two MXP_MR_2.5G
or two MXPP_MR_2.5G cards to be
automatically adjust ed.
Displays the number of GFP buffers
available between two MXP_MR_2.5G
or two MXPP_MR_2.5G cards.
This task changes the OC48 settings for MXP_MR_2.5G and
MXPP_MR_2.5G muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Chapter 10 Change Card Settings
Options
• Numeric (range depends on the client
equipment attached to the card)
Checked or unchecked
Numeric
•
Table 10-51.
September 2004