Dlp-G244 Change Orderwire Settings Using The Aic Card - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Change Card Settings

DLP-G244 Change Orderwire Settings Using the AIC Card

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
When provisioning orderwire for ONS 15454s residing in a ring, do not provision a complete orderwire
Caution
loop. For example, a four-node ring typically has east and west ports provisioned at all four nodes.
However, to prevent orderwire loops, provision two orderwire ports (east and west) at all but one of the
ring nodes.
Before you begin, make a list of the ONS 15454 slots and ports that require orderwire communication.
Tip
In node view, double-click the AIC card to display it in card view.
Step 1
Click the Provisioning > Local Orderwire tabs or Provisioning > Express Orderwire tabs, depending
Step 2
on the orderwire path that you want to create.
If needed, adjust the transmit (Tx) and receive (Rx) decibel referred to one milliwatt (dBm) values by
Step 3
moving the slider to the right or left for the headset type (four-wire or two-wire) that you will use. In
general, you should not need to adjust the dBm values.
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
September 2004
This task changes orderwire settings on the AIC card. This task applies to
ONS 15454 ANSI shelves only.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G244 Change Orderwire Settings Using the AIC Card
10-79